RCR 80v Fender Kit Install Tutorial

RCR 80v Fender Kit Install Tutorial

Standard Fender Kit


Shorty Fender Kit


Tools Required

  • 4mm hex key (Allen wrench)
  • 5mm hex key (Allen wrench)
  • 6mm hex key (Allen wrench)
  • 8mm socket or 8mm wrench

Important Installation Notes

Front Fender Bolts

  • Loctite is pre-applied to the front fender bolts.
  • The bolts may feel resistant while threading in — this is normal.
  • Continue tightening normally.

Do Not Fully Tighten Hardware Immediately

  • Leave all bolts slightly loose during initial installation.
  • Fully tighten hardware only after:
    • All brackets are aligned
    • Fender position is centered
    • Tire clearance is confirmed

Rear Fender Clamp Position

  • Ensure the rear fender clamp is:
    • Fully seated
    • Flush against the mounting surface
    • Not bowed outward

This clamp acts as reinforcement in case the weld experiences stress from aggressive riding.

Front Lower Bracket

  • The bottom front bracket should remain slightly movable during initial fitment.
  • Once alignment is finalized, fully tighten the bracket hardware.

Final Checks Before Riding

After installation:

  • Verify the fender is straight
  • Confirm there is no tire rubbing
  • Ensure all brackets:
    • Have no gaps
    • Do not rattle
    • Do not move when shaken

    • Related Articles

    • RCR 80V Alarm Kit Installation Guide

      This guide explains how to replace the factory alarm module on your RCR 80V. Tools Required 2.5 mm Allen wrench (included with the bike) 10 mm socket with extension (recommended) The 10 mm socket is optional but makes it easier to slide the seat back ...

    • RCR 80v Harness Install Guide

      This guide walks you through replacing the main wiring harness on your RCR 80V. For a complete walkthrough, follow the installation video below. Installation Video RCR 80V Wiring Harness Installation Before You Begin Power the bike off. Remove the ...

    • RCR 80V BMS App Guide

      This guide explains how to update the Battery Management System (BMS) firmware on the RCR 80V battery. Important Notes (Read First) Current BMS firmware version: v1.6 The battery case and bike frame are metal, which can interfere with Bluetooth You ...

    • RCR 80v Controller Update Guide

      This guide explains who needs a controller update, why it’s required, and how to complete the update step by step. Important Notes (Read First) Controller updates are only required for Batch 1 & Batch 2 orders Shipped between September 28th and ...

    • RCR 80V Controller Replacement Guide

      This guide explains how to replace the controller on your RCR 80V. Important: After installing the new controller, you must complete the Motor Calibration procedure before riding. Installation Video Controller Replacement Required After Installation ...